SDS

Safety Data Sheet Product: Styro FP Panels Manufacturer: Styro Industries
3
SAFETY DATA SHEET
SECTION 8: EXPOSURE CONTROLS / PERSONAL PROTECTION
Chemical Name CAS No. ACGIH, NIOSH and OSHA
quartz silica sand and aggregate 14808-60-7 0.25 mg/M
3
* TWA TLV
Portland cement 65997-15- 1 10 mg/M
3
* TWA TLV
1-chloro 1,1-difluroethane 75-68-3 1000 ppm TWA
chloro difluromentane 75-45-6 1000 ppm TWA
* Note - only as respirable.
Use appropriate engineering controls, such as providing good general ventilation, to
control airborne levels below recommended exposure limits.
Ventilation Protection: Adequate ventilation.
Recommended Respiratory Protection: If ventilation is inadequate, use a mask with
dust/mist/fume cartridges.
Recommended Skin Protection: Rubber gloves.
Other Protective Equipment: Full coveralls.
Recommended Eye Protection: Splash proof chemical goggles.
Personal Hygiene: Wash thoroughly after handling product.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Rigid lightweight decorative (finished) panel
Physical State: Solid
pH: N/A
Vapor Pressure: None
Vapor density: None
Evaporation Rate: None
Percent volatile by volume: Zero
VOC: Zero
Sp. Gr. 0.2
% Solubility (water): Not soluble.
Odor: None
SECTION 10: STABILITY AND REACTIVITY
Chemical Stability: Stable under recommended handling and storage conditions.
Hazardous Polymerization: Hazardous polymerization does not occur.
Conditions to Avoid: Extreme heat with direct flame.
Incompatible Materials: Aromatic solvents, gasoline and related materials. Oxidizers.
Special Decomposition Products: Forced thermal decomposition will release irritant
fumes and dense smoke.