Installation Instruction
INSTALLATION STEPS:
Place silicone sealant beneath the spout #1 and
insert faucet lines through the center hole of the sink.
From underneath the sink, assemble mounting
hardware (#6, #7, #8, #9).
Place silicone sealant beneath the handle
flange #2 and install through the far left hole,
repeat the same process for the right hole.
Installation Guide
Wide Spread Lavatory Faucet
Model #: B115
PAVIA
IMPORTANT NOTICES:
BEFORE YOUR INSTALLATION:
Check to make sure you have the following parts indicated below:
CARE AND CLEANING
Clean the faucet frequently using mild soap or a
non-abrasive cleaner and then quickly rinse with
water and dry with soft cloth only.
Using abrasive cleaners, solvents, acid cleaners
or any scrubbing detergent, polisher or scraper
will damage the finish and void the warranty.
email us : care@stylishkb.com
To be considered
Both handles comes with flex hose installed which should be removed
using a 10 mm wrench in order to pass handle base through contertop
hole and remove mounting nut.
Hoses should be reinstalled once handle is secured to contertop using
same wrench. ensure is NOT overtight, so just snug by hand and go an
extra half turn with wrench.
From underneath the sink, assemble gasket assembly
#3 and lock nut #4. Hand tighten lock nut #4.
Caution: Assemble in numerical order. Tighten but do
not over tighten. Use a screwdriver to tighten the 3-
screws #5 on the lock nut #4
Underneath the sink, screw the hot water
flexible hose #11 and cold water flexible hose
#11 to the faucet assembly handle body. Then
connect the flexible hot water hose from the
hot water handle assembly to the diverter #9,
hand tighten and then use an adjustable
wrench to tighten. Do not over tighten. Please
repeat for the cold water side.
NEED HELP?
Connect the hose #10 to the copper tube and water supply valve and tighten it with adjustable wrench. To
avoid breaking the copper tube, use two wrenches (as shown) to keep from twisting the supply tube from
the faucet when you tighten the nut.
FOR BEST RESULTS, WE STRONGLY RECOMMEND THE INSTALLATION OF THIS FAUCET BE DONE BY A LICENSE
PROFESSIONAL PLUMBER
MAKE SURE TO PROPERLY FLUSH THE HOT AND COLD WATER SUPPLY LINES PRIOR TO STARTING
INSTALLATION
ALWAYS TURN WATER SUPPLY OFF BEFORE REMOVING EXISTING FAUCET OR DISSASEMBLING THE VALVE.
OPEN FAUCET HANDLE TO RELIEVE ANY WATER PRESSURE AND ENSURE THAT COMPLETE WATER SHUT-OFF
HAS BEEN ACCOMPLISHED
DRAWING ARE FOR REFERENCE ONLY,REFER TO ACTUAL FAUCET FOR PRODUCT SIZE AND SHAPE
DO NOT DISASSEMBLE THE MAIN BODY, AS IT HAS BEEN INSTALLED AND COMMISSIONED CORRECTLY AND
PRECISELY BEFORE LEAVING THE FACTORY
WORKING PRESSURE AT 0.05-1.0MPa (INCLUDING COLD AND HOT WATER PRESSURE), WITH APPLICABLE
WATER TEMPERTURE (4°C- 90°C)