Manualshelf

Fitting Instructions

ManualsBrandsStyling city industries ManualsElectrical EquipmentRemote Control Light Socket
1234
Manual On/Off Switch
It is located on the side of the unit and press to On/Off the unit manually.
Important
1. Remote Light Socket unit is designed for indoor use only.
2. Do not mount the Remote Control onto any metal surface, as this will reduce the operation
range.
3.
Do not expose either unit directly to rain or immerse in water.
4. Do not mount either unit close to fireplace or expose to high temperature.
5. Dispose of old batteries in accordance with the relevant legislation.
6. There are no user serviceable parts in the unit; do not attempt to repair it.
7.
Always disconnect the unit from power supply before maintaining equipment.
8. Do not operate it with any light bulb over 60W.
9. CAUTION: Danger of explosion if battery is incorrectly installed or replaced.
10. IMPORTANT: There are no serviceable parts in the units, do not attempt to repair it.
11. NOTE: Extreme (Hot & Cold) temperature may shorten the operating range; re-locate the chime
unit if necessary.
12.
Note: The product function may reset itself when it is subjected to electrostatic discharges. Just
follow the instruction described in this manual to set the function again for normal operation.
User Hints
If the Light Socket unit does not work, please check the following:
a) Flat batteries in Remote Control or Light Socket Unit is not powered – change the batteries and
power the Light Socket.
b)
Wrong battery polarity in Remote Control – reinsert the batteries
.
c)
Both Remote Control and Light Socket units are not on the same operation codes – reset the
code (see digital code set up).
d) Erase the Light Socket operating code and repeat the code setting procedure after the Remote
Control CR2032 battery has been replaced.
e) Units are out of range – Operate the Light Socket unit within the operation range.
Specification
A. Remote Control unit
Power : 1 x 3volt CR2032 Lithium battery (included)
B. Light Socket unit
Power : A/C main power (100-110volt ~ 60Hz)
Operating Temperature: Remote Control: +5C – +35C
Light Socket: +10C – 35C