Manualshelf

Use and Care Manual

ManualsBrandsStyleWell ManualsDesksCraft White Desk with 2-Drawers
12345678910
Maintenance
If your furniture is stained or otherwise damaged during use, contact a professional for repairs.
Care and Cleaning
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polishes is not necessary. Should you choose to use polishes, test the polish in an inconspicuous area before using
over the entire surface of the product.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the finish.
Always use coasters under beverage glasses and flowerpots.
Liquid spills should be remove immediately. Using a soft, clean cloth, blot the spill gently avoid rubbing.
Always use protective pads under hot dishes and plates. Heat can cause chemical changes that may create spotting within the
furniture finish.
Use care as stains or marks from crayons or ink markers will be difficult to remove.
Be sure to immediately clean red wine or soda stains within 30 minutes or the surface will stain.
Troubleshooting
Not all of the product's legs
touch the floor
Make sure adjustable center feet levelers are adjusted properly. The levelers are pre-assembled on the
bottom of the legs.
PROBLEMS SOLUTIONS
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
10
Glide can not be assembled
Make sure the slide piece is at the front end of the glide when installing the drawer into the body.
Drawer can not be removed
When removing the drawer, tip up and press down the safety release tab to remove the drawer from the body.
The product is KD construction. You may need to loosen the bolts and place the product on a flat surface.
Ensure that the legs all touch the flat surface and then re-tighten the bolts.
Loosen all the bolts and apply some weight to the product to get all the feet to touch the floor.
Then re-tighten the bolts in that position.
Drawers cannot pull in or
pull out smoothly
Refer assembly instruction details to assemble drawers, and pull in and pull out drawers
several times gently.
Panel can not be assembled
Make sure panel is on right direction.