Instructions / Assembly

17 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
A
C
B
C
AA
A
AA
C
A
AA
Assembly (continued)
25
Attaching upright arms
□ See figure A: Fasten upper 2 screws (AA) through the upright arm (C) into the heater (A) until tight.
□ See figure B: Fasten lower 2 screws (AA) into the upright arm (C) until tight.
□ Fully tighten all 4 screws (AA) one final time.
□ Repeat the same process with upright arm (B).
WARNING: Do not lift or transport the heater by using the upright arms.
NOTE: Use hand screwdriver, not power driver to assemble fireplace insert . See BILT for video instructions.
26
Attaching logs to ember bed
1. Install left log (F) into left hole of ember bed (E) by inserting front edge of the log base into front notches of ember
bed hole.
2. Then tilt the log back to insert the rear edge of the log base into rear notches of ember bed hole (press down log
firmly to lock into position).
□ Repeat the above process for the right log (G).
IMPORTANT: Carefully follow the 2 steps below for inserting each log.
Figure A
Figure
B
G
E
E
1
2
E