Installation Guide

10. If needed, place 1/16 in. thick shims at the base

of the left side panel (C) and right side panel (D)

installation site. Trial t the left side panel (C) and

right side panel (D) on the shims and use a

sanding block if any ne adjustments are needed.

Clean the back of the left side panel (C) and right

side panel (D), the wall board and any other area

that will be in contact with the silicone adhesive

(L) with denatured alcohol and a clean rag (not

included).

11. Cut twenty 4-in. strips of installation tape (N) and

place them around the perimeter of left side

panel (C) and right side panel (D), 2 in. from the

edge and approximately 6-7 in. apart. Apply

silicone adhesive (L) in 3/4 in. diameter dots

every 6-7 in. apart over the back surface of the

left side panel (C) and right side panel (D).

Apply a thin bead of silicone adhesive (L) in the

corner of the back wall assembly. Place left side

panel (C) and right side panel (D) in place and

press rmly. Clean up any excess silicone

adhesive (L) with denatured alcohol while the

silicone adhesive (L) is still wet.

12. FRONT EDGE TRIM

Apply a continuous bead of silicone (L) along

the front edge of left side panel (C) and right

side panel (D), approximately 1/4 in. from the

edge. Attach the front edge trims (E) to the front

edges of left side panel (C) and right side

panel (D) and press rmly to secure in place.

Note: Use masking tape (not included) or

optional wood bracing to hold the front edge trim

in place while the silicone adhesive (K) cures.

ASSEMBLY INSTRUCTIONS