ITEM #2528592 2528589 VANITY LIGHT FITTER MODEL #WS120BK WS120CH Français p.10 Style Selections and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved. Español p.19 ATTACH YOUR RECEIPT HERE 800053 APPROVED FOR USE IN DAMP LOCATIONS Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-877-888-8225, 8 a.m. - 8 p.m., EST, Monday - Sunday.
TABLE OF CONTENTS Package Contents ................................................................................................................2 Hardware Contents ...............................................................................................................3 Safety Information ................................................................................................................3 Preparation .......................................................................................
HARDWARE CONTENTS (shown actual size) AA BB Wire Connector Machine Screw Qty. 3 Qty. 2 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. DANGER • For your protection and safety, carefully read and understand the information provided in this manual completely before attempting to assemble, install or operate this product. Failure to do so could lead to electrical shock, fire or other injuries that could be hazardous or even fatal.
SAFETY INFORMATION WARNING • All electrical connections must be in agreement with local codes and ordinances, the National Electric Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn about your local codes, permits and/or inspections. Risk of fire - most dwellings built before 1985 have supply wire rated for 140°F. Consult a qualified electrician before installation.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
ASSEMBLY INSTRUCTIONS 3. Remove mounting plate (B) from fixture (A) by removing screws (C) from the edges of the fixture (A). 3 A Save screws (C) for later use. B C 4. Attach mounting plate (B) to outlet box (not included) using existing washers and outlet box screws or the machine screws (BB). NOTE: If the outlet box screws required for your outlet box are of a different size than the machine screws (BB), consult a licensed electrician before proceeding.
ASSEMBLY INSTRUCTIONS 5. Unwrap BARE wire from BLACK and WHITE wires. Prepare wire by stripping 3/4 in. of insulation from wire ends using wire strippers (not included). Connect WHITE wire from fixture (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire from fixture (A) to BLACK wire from outlet box using existing wire connector or wire connector (AA).
ASSEMBLY INSTRUCTIONS 7 . Attach fixture (A) to mounting plate (B) using the screws (C) previously removed (Step 3, Page 6). Note: Before tightening screws (C) completely, use level (not included) to check fixture (A). Adjust if necessary. 7 C B C NOTE: Fixture (A) can be installed with the socket facing either up or down. C A C 8. Remove socket ring (D) from socket of fixture (A). Attach shade (sold separately) to the socket using socket ring (D).
CARE AND MAINTENANCE • Shut off main power supply. Wipe fixture with soft, damp cloth. Use window cleaner to clean glass. Do not use an abrasive cleaner on glass or fixture. TROUBLESHOOTING WARNING: Before beginning work, shut off the power supply to avoid electrical shock. PROBLEM Bulb(s) will not light. POSSIBLE CAUSE 1. Bulb(s) is/are burned out. 2. Power is OFF. 3. Faulty connection. CORRECTIVE ACTION 1. Replace light bulb(s). 2. Make sure power supply is ON. 3. Check wiring and all connections.
