Installation Guide

ASSEMBLY INSTRUCTIONS
7
6.
Wrap electrical tape (not included) around
each individual wire connector (AA) down
to the wire. Push wire connectors (AA)
gently back into outlet box. Carefully push
excess wiring into outlet box.
WARNING: Make sure no bare wire or
wire strands are visible after making
connections.
7.
Attach fixture (A) to mounting plate (B) using
the mounting plate screws (C) previously
removed (Step 3, Page 5). Note: Fixture (A)
can be installed with the sockets facing either
up or down.
NOTE: Before tightening mounting plate
screws (C) completely, use level (not included)
to check fixture (A) -- adjust if necessary.
Attach glass shades (D). Restore power and
test fixture (A).
If light does not function, please refer to
TROUBLESHOOTING.
8.
6
AA
A
AA
AA
Outlet Box
C
7
B
A
C
8
A
D