Installation Guide

Outlet Box

Washer

ASSEMBLY INSTRUCTIONS

Hardware Used

Plastic Anchor

x 2

4b.

To mount the item directly to wall, determine the

approximate location for the fixture (A). Place

mounting plate (B) against the wall and mark the

location of the holes using a pencil or a marker (not

included). Set mounting plate (B) aside.

Then, using a 1/8 in. drill bit (not included), drill two

pilot holes at the marked locations. Position plastic

anchor (DD) in each pilot hole. Gently tap plastic

anchors (DD) with a hammer (not included) until

flush with wall surface.

Use a level to adjust mounting plate (B) parallel with

floor and ceiling as needed. Secure mounting plate

(B) to wall with fixture screws (CC).

CAUTION: To mount to wall without an outlet

box, proper wiring for a light fixture must be present

and/or accessible. If not, consult a qualified

electrician before installing the fixture.

x 2

Fixture Screw

To mount the item directly to an outlet box (not

included), attach mounting plate (B) to outlet box

using the existing washers and outlet box screws or

the machine screws (BB). Note: If the outlet box

screws required for your outlet box are of a different

size than the machine screws (BB), consult with a

licensed electrician before proceeding.

Use a level (not included) to make sure mounting

plate (B) is level horizontally (shown) or vertically.

This will help ensure the fixture (A) is level when

attached. Tighten machine screws (BB) completely

to secure mounting plate (B).

CAUTION: Make sure the outlet box can support

35 lbs. hanging weight. Use metal outlet box; plastic

outlet boxes are not recommended.

4a.

Hardware Used

Machine Screw

x 2

Pilot Hole