Installation Guide

READ AND SAVE THESE INSTRUCTIONS.

SAFETY INFORMATION

HARDWARE CONTENTS (shown actual size)

• For your protection and safety, carefully read and understand the information provided in this manual

completely before attempting to assemble, install or operate this product. Failure to do so could lead to

fire, electrical shock or other injuries that could be hazardous or even fatal.

• DO NOT connect this fixture to an electrical system that does not provide a means for equipment

grounding. Never use a fixture in a two-wire system that is not grounded. Installing a fixture into an

electrical system not having a proper grounding means could cause metal parts of the fixture to carry

electrical currents if any of the fixture wires, wire connections or splices were to become broken, cut or

loose during the mounting or normal operation of the fixture. Under this condition, anyone coming in

contact with the fixture would be subject to electrical shock, which could cause serious injury or death.

• DO NOT connect the bare or green insulation fixture ground wire to the black (HOT) current-carrying

wire or the white neutral house wire. Connection of the bare or green fixture ground wire to the black

or white house wires may cause metal parts of the fixture to carry electrical currents. Under this

condition, anyone coming in contact with the fixture will receive electrical shock, which could cause

serious injury or death.

• DO NOT damage or cut the wire insulation (covering) during installation of fixture. DO NOT permit

wires to contact any surface having a sharp edge. To do so may damage or cut the wire insulation,

which could cause serious injury or death from electrical shock.

DANGER

Wire

Connector

Qty. 3

Machine

Screw

Qty. 2

• All electrical connections must be in agreement with local codes and ordinances, the National Electric

Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn about your

local codes, permits and/or inspections. Risk of fire - most dwellings built before 1985 have supply

wire rated for 140°F. Consult a qualified electrician before installation.

• To avoid personal injury, the use of gloves may be necessary while handling fixture parts with sharp

edges.

• DO NOT suspend any fixture by the house wires. A fixture must always be mounted directly to an

outlet box or to a mounting plate that is first attached to the outlet box. Wire connectors will not

support the weight of a fixture. Suspending a fixture by the house wires and wire connectors will result

in the fixture falling, with the possibility of personal injury and the danger of electrical shock or fire.

• To reduce the risk of damage to the fixture, DO NOT use power tools to assemble any part of the

fixture.

WARNING

Fixture

Screw

Qty. 2

Plastic

Anchor

Qty. 2