Installation Guide

9
ASSEMBLY INSTRUCTIONS
5
5. Install top rail (F) to xed panel (C) by inserting
screw guides (EE) into both pre-drilled holes.
Install track screws (FF) into each hole
connecting the top rail to xed panel (C). Install
roller bumper (KK) on top rail (F). Hand tighten
roller bumper (KK) with hex key (PP).
CFF
EE
KK
PP
F
Hardware Used
x 2
FF
Track Screw
x 1
KK
Roller Bumper
x 1
PP
Hex Key
6
6. Place top rail (F) to right side of wall. Ensure
top rail is level. Using a pencil, trace around the
wall bracket cover (II). Place wall bracket (HH) in
middle of traced line. Using a pencil, mark each
hole.
NOTE: If installing into tile, proceed to step 7a.
If installing into an acrylic or berglass shower
enclosure, proceed to step 7b.
F
II
HH
Hardware Used
x 1
HH
Wall Bracket Cover
x 1
II
Wall Bracket
NOTE: If you have installed the optional return panel (Item #0954411, 0954409, sold
separately), start here at Step 6 to complete assembly.