Installation Guide

ASSEMBLY INSTRUCTIONS

Note: Instructions show right-side installation. Reverse for left-side installation.

IMPORTANT NOTE: If installing the optional return panel (Item #0954411, 0954409, sold

separately), please rst refer to the instruction manual included with the return panel. Once

you are nished following the instructions for the return panel, proceed to Step 6 in these

instructions to complete assembly.

1. Set xed panel jamb (A) on shower base

threshold. Use a level to ensure panel jamb (A)

is level. Using a pencil (not included), mark the

four pre-drilled hole locations. Remove panel

jamb (A). Using a drill (not included), drill holes

approximately 1-1/2 in. deep into each marking.

NOTE: If installing into tile, use 1/4 in. masonry

bit (not included) and proceed to step 2a. If

installing into an acrylic or berglass shower

enclosure, use 1/8 in. drill bit (not included) and

proceed to step 2b.

2a. Tile installation: Insert wall anchors (CC) into

each drilled hole using rubber mallet (not

included). Place xed panel jamb (A) back into

place. Tighten 1-9/16 in. screws (BB) with

Phillips screwdriver (not included) into each

wall anchor (CC).

Hardware Used

Wall Anchor

1-9/16 in. Screw

x 4