Installation Guide

12
ASSEMBLY INSTRUCTIONS
11. Insert door guide (OO) into xed panel (C) on
front slot. Using a pencil, mark door guide (OO)
hole onto shower base threshold. Remove door
guide (OO). Drill hole on mark using 1/8 in. drill
bit. Using Phillips screwdriver, secure door guide
to shower base threshold with 1-3/4 in. screw
(LL).
11
12. Measure opening between door guide (OO)
and side wall of shower. This will be your Y
measurement. Insert threshold cover (SS) onto
right side of threshold (K). Use Y measurement
to cut left side of threshold (K) with hacksaw
(not included). Use Y measurement to cut
left side of threshold vinyl strip (J) with utility
knife (not included). Measure from left side of
threshold (K) to threshold cover (SS). This will
be your X measurement. Use X measurement
to cut notch on right side of threshold vinyl strip
(J). NOTE: When cutting threshold vinyl strip (J)
with X measurement, do not cut ap.
12
C
K
OO
C
OO
LL
C
J
K
SS
OO
X
Y
X
Y
J
Y
Hardware Used
Hardware Used
LL
Door Guide
x 1
OO
1-3/4 in. Screw
x 1
Threshold Cover
SS
x 1