Installation Guide
10
ASSEMBLY INSTRUCTIONS
7a
7a. Tile installation: Drill hole locations on wall
using a drill and 1/4 in. masonry bit. Using a rubber
mallet, insert wall anchors (CC) into each hole.
Using a Phillips screwdriver, install wall bracket
(HH) into wall using 1-3/4 in. screws (LL). Place top
rail (F) and wall bracket cover (II) into wall bracket
(HH). Hand tighten wall bracket cover (II) into place
using hex key (PP) on both top and bottom. Check
to make sure top rail is level. Hand tighten both
track screws (FF) using hex key (PP).
FF
PP
CC
LL
II
PP
HH
Hardware Used
CC
HH
II
LL
PP
Wall Anchor
Wall Bracket
Wall Bracket
Cover
1-3/4 in.
Screw
Hex Key
x 1
x 2
x 1
x 1
x 1
7b
7b. Acrylic and î‚¿berglass installation: Drill hole
locations on wall using a drill and 1/8 in. bit. Using
a Phillips screwdriver, install wall bracket (HH) into
wall using 1-3/4 in. screws (LL). Hand tighten wall
bracket cover (II) into place using hex key (PP) on
both top and bottom. Check to make sure top rail
is level. Hand tighten both track screws (FF) using
hex key (PP).
FF
PP
LL
II
PP
HH
Hardware Used
HH
II
LL
PP
Wall Bracket
Wall Bracket
Cover
1-3/4 in.
Screw
Hex Key
x 1
x 1
x 1
x 1