Installation Guide

15
ASSEMBLY INSTRUCTIONS
19. Move door panel (E) to closed position. Door
(E) should be fully ush with magnet seal (jamb)
(H). If door (E) is uneven, remove cap on back
of right top roller (GG). Use spanners (RR) to
adjust angle of door until fully ush with magnet
seal (jamb) (H).
19
20. Caulk both vertical and bottom seams. Place
aluminum cap (AA) on top left corner of door.
Allow 24 hours for caulk to dry before using.
20
AA
GG
E
RR
Hardware Used
Hardware Used
18. Slide magnet seal (jamb) (H) over door jamb (I).
18
I
H
Spanner
RR
x 1
Aluminum Cap
AA
x 1