Installation Guide
14
ASSEMBLY INSTRUCTIONS
17a
17b
I
CC
I
BB
BB
17a. Tile installation: Insert wall anchors (CC) into
each drilled hole using rubber mallet. Place
door jamb (I) back into place. Tighten 1-9/16
in. screws (BB) with Phillips screwdriver into
each wall anchor (CC).
17b. Acrylic and î‚¿berglass installation: Place
door jamb (I) back into place. Tighten 1-9/16
in. screws (BB) with Phillips screwdriver into
each drilled hole.
16. Set door jamb (I) in middle of traced line. Ensure
door jamb (I) is level. Using a pencil, mark the
four pre-drilled hole locations. Remove door
jamb (I). Using a drill (not included), drill holes
approximately 1-1/2 in. deep into each marking.
NOTE: If installing into tile, use 1/4 in. masonry
bit and proceed to step 17a. If installing into an
acrylic or î‚¿berglass shower enclosure, use 1/8
in. drill bit and proceed to step 17b.
16
I
Hardware Used
Wall Anchor
1-9/16 in. Screw
CC
BB
x 4
x 4
Hardware Used
1-9/16 in. Screw
BB
x 4