Installation Guide

9
11
ASSEMBLY INSTRUCTIONS
B
F
E
F
E
DD
EE
Top
View
10b. Acrylic and berglass installation: Place
strike adjustment rail (E) back into place.
Tighten 1-1/2 in. screws (GG) with Phillips
screwdriver into each drilled hole. Press screw
caps (EE) over each 1-1/2 in. screws (GG).
Note: When installing strike adjustment rail (E),
the small holes along the side must face the
inside of shower enclosure
GG
E
EE
10b
11. Slide magnetic strike (F) over strike adjustment
rail (E). Tighten 3/8 in. screws (DD) with Phillips
screwdriver into each pre-drilled hole located on
the side of strike adjustment rail (E) to secure
magnetic strike (F). Press screw caps (EE) over
each 3/8 in. screws (DD).
Hardware Used
1-1/2 in. Screw
GG
x 3
EE Screw Cap x 3
Hardware Used
3/8 in. Screw
DD
EE Screw Cap x 3
x 3