Installation Guide

6
ASSEMBLY INSTRUCTIONS
4. Set pivot jamb (A) on threshold (D) ush to the
inside edge of the lip. Use a level to ensure pivot
jamb (A) is plumb. Using a pencil (not included),
mark the ve pre-drilled hole locations. Remove
pivot jamb (A). Using a drill (not included), drill
holes approximately 1-1/2 in. deep into each
marking.
NOTE: If installing into tile, use 1/4 in. masonry
bit (not included) and proceed to step 5a. If
installing into an acrylic or berglass shower
enclosure, use 1/8 in. drill bit (not included) and
proceed to step 5b.
4
5a. Tile installation: Insert wall anchors (FF) into
each drilled hole using rubber mallet (not
included). Place pivot jamb (A) back into
place. Tighten 1-1/2 in. screws (GG) with
Phillips screwdriver into each wall anchor (FF).
5a
5b. Acrylic and berglass installation: Place
pivot jamb (A) back into place. Tighten 1-1/2
in. screws (GG) with Phillips screwdriver into
each drilled hole.
A
A
D
5b
GG
FF
GG
A
A
Side
View
Hardware Used
Wall Anchor
1-1/2 in. Screw
FF
GG
x 5
x 5
Hardware Used
1-1/2 in. Screw
GG
x 5