Installation Guide

5
ASSEMBLY INSTRUCTIONS
1. Measure bottom nished opening. Using
handsaw (not included), cut threshold (D) to 1/16
in. less than nished opening measurement.
1
D
2. Run a bead of silicone caulk (not included) along
bottom lip of threshold (D) and place on shower
base threshold with the caulk bead facing the
outside of shower opening. Press rmly against
the entire length of threshold (D). Allow time for
caulk to fully dry per manufactures' instructions.
Note: Sloped side of threshold (D) must face the
inside of shower.
2
3. With a Phillips screwdriver (not provided), fully
tighten pivot bracket arm (AA) to bottom of pivot
jamb (A) using 1-1/4 in. screws (CC). Repeat on
top of pivot jamb (A). Only tighten screws 1/4 for
glass panel installation during step 7.
3
D
D
CC
A
AA
Note: Instructions show right-side installation. Reverse for left-side installation.
Side
View
Hardware Used
AA
Pivot Bracket Arm x 2
CC
1-1/4 in. Screw
x 4