Installation Guide

4
transolid.com
ASSEMBLY INSTRUCTIONS
3
3. If needed, place 1/16 in. thick shims (not included)
at the base of the back panel’s (A) installation site.
Trial t the back panel (A) on the shims and use a
sanding block if any ne adjustments are needed.
Remove back panel (A) from wall and clean the
back of the panel (A), the wall board and any other
area that will be in contact with the silicone (K)
with denatured alcohol and a clean rag (both not
included).
A
2. Check the measurements, and then place
masking tape (not included) over the area where
the saw (not included) will contact the nished
side of the back panel (A). Cut the back panel (A),
and make any nal adjustments to the cuts with
a sanding block (not included).
2
A
Masking
Tape
1
1. BACK PANEL
Determine the width of the back wall panel
(A) by measuring from the top of the shower base
Measure the width of the opening from these
points. Note: If the wall is not square, you can use
cardboard (not included) to create a template of
the wall and transfer the data to the back panel (A).
Measure
72 in.