Installation Guide

6
ASSEMBLY INSTRUCTIONS
5.
You may need to cut the excess wire to simplify the
wiring. You will need at least 10 in. of wire to work
with.
Prepare wire by stripping 3/4 in. of insulation from
wire ends using wire strippers (not included).
6.
If you wish to change cord length, loosen (but do not
remove) plastic piece preassembled on cord on
inside of canopy of fixture (A).
Loosen cord restraint and adjust cord to desired
hanging length by pulling cord up through canopy of
fixture (A) until at proper length.
Tighten cord restraint to hold cord at desired length.
CAUTION: Do not overtighten cord restraint.
Move plastic piece back over opening on inside of
canopy.
A
5
A
Cord
Restraint
Plastic
Piece
Canopy
10 inches
6
A