Installation Guide

16
2
1
1
2
New board at an angle
Existing Deck
3
4
4
1
1
3
2
2
2
3
1
HOW TO INSTALL DECKING
HOW TO REPLACE STYLE SELECTIONS™ BOARDS
INSTALLED WITH STAINLESS STEEL FASTENERS
HOW TO REPLACE STYLE SELECTIONS™ BOARDS
INSTALLED WITH TREX HIDEAWAY
®
UNIVERSAL FASTENERS
Stainless Steel Fasteners
1. Mark the board to be replaced in thirds. Cut each side
of middle section and remove it. Remove remaining two
sections.
2. Hammer down the exposed side of the connector clips.
Place the new board into position using a pry bar to maneu-
ver it into place. Secure board on grooved edge with finish
nails, screws or use counter drill, screws and plugs.
Universal Fasteners
1. Remove screws from fasteners on both sides of board to
be replaced and remove board.
2. Angle new board to place.
See inset box (above).
3. Slide a fastener for each joist into board grooves
from both ends of the board.
NOTE: You may have to loosen adjacent boards to
slide fasteners into position.
4. Position replacement board and secure fasteners
on center of each joist.
3
Insert Fasteners
Insert Fasteners