Installation Guide

Prepare wires by stripping 3/4 in. of insulation from wire
ends using wire strippers (not included).
Connect WHITE wire from fixture (A) to WHITE wire
from outlet box using existing wire connector or wire
connector (CC).
Connect BLACK wire from fixture (A) to BLACK wire
from outlet box using existing wire connector or wire
connector (CC).
Connect BARE/GREEN ground wire from outlet box to
BARE ground wire from fixture (A) with wire connector
(CC).
NOTE: Screw wire connectors (CC) on in a
clockwise direction.
WARNING: Never connect ground wire to WHITE
or BLACK power supply wires.
WARNING: To reduce the risk of fire, electrical
shock or personal injury, wire connectors (CC) are
designed to accept only one 12-gauge house wire and
two lead wires from the light fixture. If your house wire is
larger than 12-gauge or there is more than one house
wire to connect to the corresponding fixture lead wires,
consult an electrician for the proper size wire connectors
to use.
Hardware Used
Wire Connector
x 3
CC
HARDWIRE INSTALLTION
5.
Wrap electrical tape (not included) around
each individual wire connector (CC) down
to the wire. Push wire connectors (CC)
gently back into outlet box. Carefully push
excess wiring into outlet box.
WARNING: Make sure no bare wire or
wire strands are visible after making
connections.
WARNING: Make sure plastic piece is
at least 15cm from the wire ends.
6.
9
2
5
2
6
Plastic Piece
A
CC
Wire box
cover
Outlet Box
15cm.
A
CC
Wire box
cover
WHITEWHITE
BLACK BLACK
BARE/GREEN
Plastic Piece