Installation Guide

7
2.
3.
3
WARNING: The power cord is equipped with
a three-prong grounded plug that must be
inserted into a matching receptacle. Under no
circumstances must the grounding prong be cut
off the plug. Where a two-prong wall receptacle is
encountered, it must be replaced with a properly
grounded three-prong receptacle installed in
accordance with the National Electrical Code and
all applicable local codes and ordinances.This
work must be done only by a qualified electrician,
using copper wire only.
Insert the power cord (C) preassembled on
fixture (A) into proper wall outlet.
PLUG-IN INSTALLATION
Hang fixture (A) using the keyhole slots on the
back of fixture (A).
2
Keyhole
Slot
A
HARDWIRE INSTALLATION
Open the round wire box by removing the
screws on the wire box cover.
NOTE: Do not remove the round wire
box cover.
1.
A
Wire Box
Cover
1
Screw
C