Installation Guide

6
3
3.
Position plastic anchor (BB) in each pilot hole.
Gently tap plastic anchors (BB) with a hammer
(not included) until flush with wall surface. Screw
fixture screw (AA) into plastic anchor (BB) about
1/8 - 5/16 in. of the screw to remain showing.
Hardware Used
AA
x 4
Fixture Screw
Pilot Hole
BB
BB
AA
AA
Plastic Anchor
x 4
BB
2.
2
Pilot HoleTemplate
Template
1
Before hanging the fixture (A), place power cord (C)
through one of the two slots on the back of the
fixture (A).
1.
Slot
Slot
A
INITIAL INSTALLATION
PLUG-IN INSTALLATION
Determine the approximate location for the fixture (A).
Place a template (not included) against the wall, and
mark the location of the holes using a pencil or a
marker (not included).
If mounting surface is wood, use a 5/64 in. drill bit (not
included) to drill the fixture screws (AA) in wood at
marked locations.
Proceed to one of the two
installation options (Plug-In or Hardwire).
If mounting surface is drywall, use a 5/16 in. drill bit
(not included) to drill four pilot holes in drywall at
marked locations. Continue to Step 3.
NOTE: The fixture (A) can be hung vertically, or
horizontally.
C