Installation Guide

5
Lowes.com
ASSEMBLY INSTRUCTIONS
4. Re-attach fixture body (B) to crossbar assembly (A)
using previously removed mounting balls (Step 1,
page 4). Hand tighten until snug.
Note: Remove the protective film from the fixture body
(B) before proceeding to the next step.
5. Insert bulbs (C) into fixture sockets, then cover with
bulb shields (D). Hand tighten until snug.
IMPORTANT: Do not touch the bulb with bare
hands, as oil from your skin can damage the bulb;
use a soft cloth or gloves.
AA
Hardware Used
3
4
5
White Wire
From Outlet Box
Black Wire
From Outlet Box
Bare, or Green
Ground Wire
Bare, or Green
Fixture Ground Wire
From Outlet Box
Bare, or Green
Ground Wire
From Outlet Box
White or
Ribbed Side
From Fixture
From Fixture
Black or
Smooth Side
OR
x 3
Wire
Connector
AA
C
A
B
3. Attach ground fixture wire to either the green ground
screw preassembled on the crossbar assembly (A) or
to the ground wire in the outlet box (usually GREEN
or BARE). If attaching fixture ground wire to the
crossbar assembly (A), it is imperative the outlet box
in your home be properly grounded.
Connect the neutral (WHITE or RIBBED) fixture wire
to the neutral (usually WHITE) wire from the outlet
box. Connect the hot (BLACK or SMOOTH) fixture
wire to the hot (usually BLACK) wire from the outlet
box. Fasten wires together with wire connectors (AA)
and tightly wrap wire connectors (AA) with electrical
tape (not included).
Green Ground Screw
Protective Film
D
Mounting Ball