Installation Guide

4
ASSEMBLY INSTRUCTIONS
Lowes.com
1
Hardware Used
BB
x 2
Outlet Box
Screw
1. Unscrew the preassembled mounting balls on crossbar
assembly (A) and detach it from fixture body (B). Save
hardware for later use, then attach the crossbar
assembly (A) to the outlet box (not included) with outlet
box screws (BB). Do not tighten yet.
Note: The preassembled mounting screws on the
crossbar should protrude outward.
Note: In order to keep the fixture clean, do not remove
the protective film on fixture body (B) yet.
Hardware Used
CC
x 2
DD
x 2
A
BB
Outlet Box
Mounting
Hole
2. Using a pencil (not included), mark the locations on
the ceiling that correspond with the holes on crossbar
assembly (A). Using a 5/16-inch drill bit (not included),
drill pilot holes at marked locations.
For drywall installations, insert wall anchors (DD) into
the holes. Otherwise, secure crossbar assembly (A)
using self-tapping screws (CC). Then, fully tighten the
outlet box screws (BB).
CAUTION: Do not overtighten the screws as damage
to the bracket could occur.
2
A
CC
Wall
Anchor
Self-tapping
Screw