Installation Guide

DDDD

29 3/8 in.Template

2. Using a 3/16 in. drill bit (not included), drill holes

marked on thewall. Place a Phillips screwdriver (not

included) in recess of anchor (BB). Slowly turn anchor

(BB) clockwise with slight pressure until the flange

just touches the wall at each pencil mark.Do not push

against anchor (BB) using the drill (not included).

ASSEMBLY INSTRUCTIONS

23 1/2 in.Template

CCCC

x 1

BBBB

AAAA

Anchor x 2

Screw x 2

1. If you want to hang the mirror vertically, place 23 1/2 in

template (CC) on the wall and use it to determine the

insertion points of the anchors (BB). If you want to

hang the mirror horizontally, place 29 3/8 in template

(DD) on the wall and use it to determine the insertion

points of the anchors (BB). Use a penci l

to mark the wall through the holes of template. Use a

level (not included) to ensure the mirror (A) will be

leveled and plumb against the wall.

(not included)

Hardware Used

3. Insert screw (AA) into holes of anchor (BB) and

turn clockwise. Tighten screw (AA) until it becomes

difficult to turn.

DDDD

CCCC