Installation Guide

Lowes.com

Power:

Push button to turn on or turn off. If OFF,

heater will be restored at the next power ON.

Note:

Unplugging the unit will reset all functions.

Flame:

Press to activate the ame function. This

button controls the brightness of ame and ember

effect. When the replace is rst turned on, the ame

will come on at the highest setting; press DOWN or UP

button to adjust the brightness of ame. There are 6

levels you can cycle through, including the OFF setting

(the ember remains on). When adjusting the ame

brightness with UP and DOWN button, the number of

the ame level bars corresponds to the 5 brightness

levels. When this feature is on, display screen FLAME

icon is on also.

Heater:

Press to activate the heater function. The

system will start the temperature setting at 95°F.

There are 7 adjustable heat levels, ranging from 65°F

to 95°F. Press the DOWN or UP button to adjust the

levels, noting each level increases or decreases the

temperature by 5°F. When this feature is on, display

screen HEATER icon is on also. And when this feature

is off, the inner blower will continue to run for additional

1 minutes to cool down the unit in order to protect the

heating elements before the unit completely shuts off.

Note:

You can switch the temperature display from

Fahrenheit to Celsius by pressing and holding the

HEATER button on control panel for approximately 6

seconds. Without any adjustments after approximately

6 seconds, the display screen will show the room

temperature.

OPERATING INSTRUCTIONS