Installation Guide

5
Hardware Used
6.
7.
Hardware Used
CC
DD
OUTLET BOX
6
4
4. Connect all of the wires (white wires from
the fixture to the white wires from the supply
circuit, black wires from the fixture to the
black wires from the supply circuit, and the
copper wire from the fixture to the copper
wire of the supply circuit) using the wire nuts
(CC). Wrap electrical tape around wire nuts
(CC) and be sure they are secure. Push all
excess wire and wire connections back into
the outlet box.
Wire Nut x 3
5
Hardware Used
7
Suction Cup
x 1
C
DD
A
AA
CC
D
Mounting Crossbar
AA
x 1
5. Push fixture (A) flush to the mounting surface,
securing to mounting crossbar (AA) with set screw
(D). Note: Make sure there is no gap between the
canopy of fixture (A) and the mounting surface.
While holding a socket on fixture (A) with one hand,
slide the glass shade (B) over the tension clips
preassembled to the socket with the other hand.
Rotate the glass shade (B) until it is secure and
there is no gap between it and the fitter.
Repeat for remaining glass shades (B).
Lowes.com
®
While still holding the sockets on fixture (A), install
the bulbs (C) using suction cup (DD).
Note: The suction cup (DD) must be flat against the
bulb (C). Pull the tail of suction cup (DD) to rotate
the bulb (C) -- clockwise to secure, counterclockwise
to remove.
B
6