Installation Guide

ASSEMBLY INSTRUCTIONS
8
In order to attach arm (F) to arm support (G), first,
align the small tab at the top of the arm (F) with
the small, corresponding hole located on the arm
support (G). Gently push down on the arm
support (G) until tab goes through small hole.
Then insert 10mm screw (DD) into larger hole to
secure arm (F) to arm support (G). Tighten 10 mm
screw securely with a Phillips screwdriver (not
provided).
Repeat for remaining arm (F).
NOTE: Arm preassembled to arm support (G) only
needs to be secured with small screw (DD).
6.
Attach bottom end of one arm (F) to fixture (A)
using 14 mm screw (CC) provided. Be sure arm
(F) is completely secure before proceeding.
Repeat for each arm (F).
IMPORTANT: Since arm support (G) is
preassembled to one arm (F), arm support (G)
should now be centered.
5.
Hardware Used
14 mm Screw
x 3
CC
4
6
A
F
F
G
G
DD DD
Hardware Used
10 mm Screw
x 3
DD
7.
First, pull cord from top of the canopy (D), then
screw cap (H) onto arm support (G). Next,
screw the canopy (D) onto top of rod (E). Be
sure rod (E) is completely secure before
proceeding.
NOTE: Keep cord taut, ensuring it does not get
tangled or pinched.
4
7
G
H
E
D
Cord
Cord
Tab
G
4
5
A
CC CC
F
F
F