Installation Guide

4
ASSEMBLY INSTRUCTIONS
2. Position threaded nipple (C) in mounting bracket
(B) so that, when mounted:
• The threaded nipple (C) will protrude a
minimum of 1/4 inch beyond the raised center
portion of the bracket (B).
• The threaded nipple (C) height should be
positioned so that 1/2 the exterior threads of
the screw collar loop (I) will extend past the
canopy (A), when it is mounted.
3. Once the proper position of the threaded nipple
(C) and bracket (B) has been determined,
secure with hex nuts (D) as follows:
• Screw one hex nut (D) onto the threaded
nipple (C) and tighten against the raised
portion of the bracket (B).
• Screw another hex nut (D) onto the threaded
nipple (C) and tighten against the flat portion
of the mounting bracket (B).
• Screw the remaining hex nut (D) onto
threaded nipple (C) and tighten against the
screw collar loop (I).
3
1/4 Inch
D
C
I
B
1. Screw threaded pipe (J) into coupling (F).
Screw fixture loop (L) into threaded pipe (J).
2
B
A
1/4 Inch
I
C
Lowes.com
1
L
J
F