ITEM #0673803 ELECTRIC FIREPLACE WITH MEDIA MANTEL Style Selections® is a registered trademark of LF, LLC. All rights reserved. MODEL #88294/26MM20243-C278 Français p. 18 Español p. 35 Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-877-888-8225, 8 a.m. - 8 p.m., EST, Monday - Friday. EB15195 1 Lowes.
TABLE OF CONTENTS Product Specifications .......................................................................................................................... 2 Safety Information................................................................................................................................. 3 Package Contents................................................................................................................................. 6 Hardware Contents...............................
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: DANGER: • This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never place this appliance where it may fall into a bathtub or other water container.
. The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. SAFETY INFORMATION 5. Always unplug this appliance when not in use. 6. Do not operate any heater with a damaged cord or plug or after the appliance malfunctions, or if it has been dropped or damaged in any manner. • 7.
SAFETY INFORMATION • Batteries are to be inserted with the correct polarity. • Exhausted batteries are to be removed from the product • Non-rechargeable batteries are not to be recharged. SAVE THESE INSTRUCTIONS. Cold-climate installation: It is mandatory the outer walls be insulated to conform to applicable insulation codes. ELECTRICAL CONNECTION A 15-Amp, 120-volt, 60 Hz circuit with a properly grounded outlet is required.
PACKAGE CONTENTS G O O H D J C K H F I B Q M N E A L P R PART A B C D E F G H I J K L M N O P Q R DESCRIPTION Front Base Left Side Panel Right Side Panel Center Front Panel Left Door Right Door Mantel Top Wood Shelf Left Partition Right Partition Insert Support Bar Left Base Right Base Lower Insert Support Bar Rear Panel Insert Remote Tipping Restraint Hardware Pack 6 QUANTITY 1 1 1 1 1 1 1 2 1 1 1 1 1 1 2 1 1 1 Lowes.
HARDWARE CONTENTS (shown actual size) AA BB CC DD Bolt Qty: 28 Washer Qty: 28 Wood Dowel Qty: 16 Truss Head Screw Qty: 28 EE Shelf Pin Qty: 8 FF Door Pull (Not to scale) Qty: 2 HH II JJ Screw Qty: 16 Magnetic Spring Catch (Not to scale) Qty: 2 Catch Screw Qty: 4 Hinge (Not to scale) Qty: 4 KK W3348A GG Touch-up Pen (Not to scale) Qty: 1 7 Lowes.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. To protect the product from possible scratches, please assemble the parts on a scratch-free surface. Estimated Assembly Time: 60 minutes Tools Required for Assembly (not included): Phillips screwdriver, scissors and utility knife.
4. Attach center front panel (D) between left partition (I) and right partition (J) using bolts (AA) and washers (BB). 4 BB AA Hardware Used AA Bolt x2 BB Washer x2 D I J 5. Insert wood dowels into assembly where shown, then attach mantel top (G). Secure from underneath using bolts (AA) and washers (BB). 5 CC BB Then, before proceeding to the next step, go back with a Phillips screwdriver (not included) and ensure all connections are tight.
7. Attach the hinges (JJ) to the left door (E) and right door (F) using screws (GG) and tighten securely. 7 GG Hardware Used GG Screw x8 JJ Hinge x4 JJ F E 8. Attach right door (F) to right side panel (C) through hinges (JJ) using screws (GG). Tighten with Phillips screwdriver. Then, remove the preassembled bolt from a door pull (FF) and install door pull (FF) to right door (F) using the bolt. 8 Repeat this step for left door (E).
WARNING: Be sure to read all safety information prior to installing the insert (P). Insert (P) should be installed in the fireplace as close to the final position as possible; two people are recommended for this step. 10. Lift insert (P) carefully into the back of the unit and center in the insert opening. Do not drag insert (P) across front base (A) as it may scratch the unit. Connect the insert support bar (K) to the left partition (I) and right partition (J) using bolts (AA) and washers (BB).
. WARNING: Installing the tipping restraint hardware will help prevent accidents and/or damage to the unit. It is highly recommended you complete this step. To secure the item to the wall, find and mark a stud closest to the edge of the left side of the mantel. Attach the wall anchor from the tipping restraint hardware pack (R) at the marked locations using 2 of the screws from the pack. Attach the unit anchor to the mantel top (G) using the remaining 2 screws so it aligns with the wall anchor.
OPERATING INSTRUCTIONS The heater can be operated by either the remote control or the control panel. Control Panel Display Front View of Insert (P) FUNCTION POWER ICON Remote (Q) DESCRIPTION Use the POWER button to turn on or off the fireplace from the remote or control panel. Note: Holding the POWER button on the control panel for 10 seconds will disable the heater function. To re-enable the heater, press and hold the POWER button for another 10 seconds.
CARE AND MAINTENANCE • Dust the fireplace regularly with a soft, non-lint producing cloth or household dusting product. • Clean the fireplace with a gentle non-abrasive household cleaner. Make sure to dry the fireplace immediately with a soft cloth or towel. • Tips for using touch-up pen (KK): For scratches, stroke in direction of scratch. For worn areas, stroke in direction of wood grain. Rub excess cororant promptly with a soft cloth.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Display shows “ ” The thermostat sensor is broken or disconnected. Unplug the fireplace, remove the back panel of the fireplace and check that the thermostat is plugged into the main circuit board. If this does not solve the problem contact customer service for a replacement thermostat sensor. Display shows “ ” The thermostat sensor is broken. Contact customer service for a replacement thermostat sensor.
1-YEAR LIMITED WARRANTY The manufacturer warrants this product to be free from manufacturing and material defects for a period of one year from date of purchase, subject to the following conditions and limitations. 1. Install and operate this item in accordance with the installation and operating instructions furnished with the product at all times. Any unauthorized repair, alteration, willful abuse, accident, or misuse of the product shall nullify this warranty. 2.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-877-888-8225, 8 a.m. - 8 p.m., EST, Monday - Friday. PART DESCRIPTION PART NO.
