Installation Guide

ASSEMBLY INSTRUCTIONS

Hardware Used

3. Place the assembly in the desired location and

mark the mounting points on wall through the

holes in the back tubes of the unit.

NOTE: Wall anchors (EE) should be oriented

with the at side horizontal.

Hammer the wall anchors (EE) into wall, unless

mounting screws (DD) will go directly into a stud.

Insert the mounting screws (DD) through the

holes in the back tubes and place unit against the

wall, lining up the mounting screws (DD) to the

holes in wall.

Complete the mounting by tightening mounting

screws (DD) into the studs or wall anchors (EE),

as shown.

Wall Anchor

x 2

Mounting Screw

x 2

Hardware Used

4. Place the assembly in the desired location and

attach the straight tube (F) to the bottom sides (E)

with screws (BB), as shown.

Screw

x 2

IS20065-I2