Installation Guide

MIRROR INSTALLATION INSTRUCTIONS

4. With the assistance of another adult, lift mirror (H)

to the wall and hang mounting hangers (G) on screws

(BB).

3. If the wall is drywall, there is no need to drill pilot holes

for wall anchors (AA). Screw anchors (AA) flush into the

wall. Then, insert screws (BB) into anchors (AA), leaving

approximately 1/4 in. protruding out from the wall.

If the wall is not drywall, please choose appropriate

mounting hardware (not included) for your installation site,

and follow the installation instructions to secure the

mounting hardware to the wall.

Note: The distance between the holes in the mounting

hangers (G) on the back of the mirror (H) is 20 1/4”

(514mm).

Note: Make sure to allow height clearance along the

bottom of the mirror for your faucet is necessary.

Anchor

x 2

Screw

x 2

Hardware Used

2. Measure and mark location for mounting hardware on

the wall using the measurement from Step 1. Make

sure the marks are level and located at the desired

height.

1. Measure the distance between the holes in the

mounting hangers (G) on the back of the mirror (H).

Vertical mounting: 20 1/4”(514mm)

1/4 in.