Installation Guide

INSTALLATION INSTRUCTIONS

WARNING

Vanity (A) MUST be secured to wall.

Note: Clean area where the vanity (A) will be

permanently located prior to beginning installation,

ensuring the vanity (A) will not interfere with any

water supply and drain lines once mounted.

With the help of another adult,

carefully place

vanity (A) against the wall in its final location.

From inside vanity (A), drill hole through vanity

mounting area and into wall studs. Using

mounting hardware (not included) appropriate

for your installation site, secure vanity (A) to

wall stud. If possible, secure vanity (A) to

two wall studs for increased stability.

Note: Use preassembled levelers on legs of

vanity (A) to level the item. Twisting the

levelers counterclockwise will increase the

height of vanity (A), twisting them clockwise

will decrease it.

2. To remove drawers from vanity base (A),

fully extend drawers and locate the plastic

levers on left and right sides of the metal glide

tracks. Push the plastic levers, on both sides,

at the same time, This will disengage the

drawer box from the glides. Gently lift up on

the drawer to remove it from the glide tracks.

Set aside as these will be re-installed.

Mounting Plate