Installation Guide

To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Using a correct size spanner unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
7: Replace them in turn.
ALLEN
KEY
FAUCET
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
GRUB
SCREW
CAP
Dimensions
Installation
1: Twist hose into the mixer body .Put washer into the groove of faucet body.
2: Pass hose and thread pipe through the table hole. And twist the fixing nut to the thread pipe. Adjust the mixer body and fix firmly.
Unit:inches
2.36″
max1.18″
6.82″
3.69″
4.69″
Hose
Washer
Faucet
Rubber Washer
Metal Washer
Fixing Nut
Lift pole
Drain
Concave
Washer
Metal
washer
Drain off pole
Mounting
Nut
3:
Insert the lift pole through the hole at the back of the faucet body.
4:
Insert the drain through the hole of the basin.attach concave washer, metal washer , and mounting nut to drain .Tighten the drain
securely.Insert shortest end of drain-off pole into drain body . Place the end side of the lift pole through the drain-off pole and then
ighten the screw.