Installation Guide

4.5″
1.7″
6.8″
3.5″
Ø 1.4″
max1.1″
Installation
Dimensions
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Using a correct size spanner unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6. Dry and lightly grease the seals (only use silicone grease)
7: Replace them in turn.
1: Fit the O-ring in the underside of the mixer body.
2: Screw the male screw and the flexible hoses into the mixer body, and fully hand tighten.
3: Pass the tail of flexible pipes through the hole on the basin from above, and place the mixer in position on the basin, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Tighten the rubber washer, the brass washer with the female screw from the under-side of the counter.
5: Check that the mixer body is correctly positioned, fully tighten the female screw.
6:
Connect the water supply pipes to the tail of flexible hoses with the hot water and cold water.
FAUCET
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
ALLEN
KEY
GRUB
SCREW
CAP
Unit:inches
Faucet
Hose
Male Screw
Square Washer
Rubber Washer
Brass Washer
Female Screw
Spanner