Getting started: Sledge 2.0

SLEDGE 2.00
3
Pitch Wheel & Hold Controls: this new page (n°4) of the Global allows to select
if the related Pitch Wheel and Hold pedal controls should be enabled for Upper or
Lower sounds or both.
Pitch Bend Global control
Hold Pedal Global control
To select the desired function, move the cursors on the upper or lower row and set
the function by rotating the encoder until the desired status will be enabled:
UPP: only on Upper – LOW: only on Lower – ALL: on Upper and Lower
note: the function will be activated only in DUAL MODE and for all DUAL sounds, since
it is a GLOBAL control not related to a specific sound or program change.
As an example of a typical use, imagine to have a DUAL sound where you mix
SAMPLES on a Lower sound (a Piano sound or Drums grooves) and a Synth solo as
Upper; in this case the PITCH should be active on Upper and the HOLD on Lower, for
the best performance control.
EFFECTS 2 Mix: Sledge 2.0 allows to mix the Effect 2 types Rev and Delay, by
selecting the related function by pressing in sequence the TYPE BUTTON that will set
the effects in this looping configuration, shown by the related led lighted accordingly:
(both led off) OFF >REVERB>DELAY>REVERB+DELAY> (both led on)
Note: the setting or Reverb will be kept as it was before selecting a dual effect; when
both REVERB + DELAY are selected, the editing can be done on the DELAY only, as
shown in the display