Manual

Issue 2, August 2015 Model 5202 User Guide
Page 12 Studio Technologies, Inc.
Model 5202
Dante to Phones and Line Output Interface
Ultimo Firmware Update
As previously discussed in this guide, the
Model 5202 implements Dante connectivity
using the 2-input/2-output Ultimo integrat-
ed circuit from Audinate. The Dante Con-
troller software application can be used
to determine the version of the firmware
(embedded software) residing in the Ultimo
“chip.” This firmware can be updated by
way of the Model 5202’s Ethernet connec-
tion. The latest Dante firmware file is avail-
able on the Studio Technologies website.
The Dante Firmware Update Manager
application is used to install the firmware.
This program is also available for down-
load on the Studio Technologies website.
Identifying the Firmware
Version Number
As previously discussed in this guide,
upon power up the meter LEDs are used
to briefly display the version number of
the Model 5202’s firmware (embedded
software). This information is typically only
necessary when working with the fac-
tory on support issues. The meter LEDs
will first go through a display sequence
followed by an approximately 1-second
period where the version number will be
indicated. The top row of seven LEDs will
display the major version number with a
range of 1 to 7. The bottom row of seven
LEDs will display the minor version number
with a range of 1 to 7. Refer to Figure 2 for
details.
Figure 2. Detail of front panel showing the LEDs that display the firmware version.
In this example, the version shown is 1.3.
Major Version Number
1 2 3 4 5 6 7
 O O O O O O
O O  O O O O
.1 .2 .3 .4 .5 .6 .7
Minor Version Number