Manual

Issue 2, July 2018 Model 48D User Guide
Page 18 Studio Technologies, Inc.
if the Automatic IP configuration method
has been selected. Dante Controller can
be used to change a fixed (“static”) IP ad-
dress. A button-press sequence can also
be used to change this value if the Manual
IP configuration method has been select-
ed. Refer to the Configuration section of
this guide for details.
Net A Subnet Mask
This field displays the subnet mask value
actively being used by the Ethernet inter-
face associated with Network A. This value
will be provided by the DHCP or link-local
process if the Automatic IP configuration
method has been selected. Dante Control-
ler can be used to change a fixed (“static”)
subnet mask value. A button-press se-
quence can also be used to change this
value if the Manual IP configuration meth-
od has been selected. Refer to the Con-
figuration section of this guide for details.
Net A Sample Rate
This is a display-only field that will show
the sample rate active for the Network A
Dante interface. The possible rates will
be 44.1kHz, 48kHz, 88.2kHz, and 96kHz.
If AES67 mode is enabled the only valid
sample rate will be 48 kHz. Selecting the
active sample rate is performed using the
Dante Controller application.
Net A AES67
This is a display-only field that shows the
status of the AES67 Mode for Network
A. The possible values are
Disabled and
Enabled. Selecting the AES67 Mode is
performed using the Dante Controller
application.
Main Firmware Ver
This is a display-only field that shows the
version of the main firmware (embedded
software) that is currently being used in
the Model 48D’s microcontroller integrated
circuit. This is not related to the version of
firmware associated with the two Dante
Interfaces. Additional details regarding
the main firmware can be found in the
Technical Notes section of this guide.
Net A Product Ver
This is a display-only field that shows the
version of the Dante firmware (embedded
software) that is currently being used in
the Ultimo integrated circuit associated
with Network A. This is not related to the
version of the main firmware associated
with the Model 48D’s microcontroller inte-
grated circuit. Additional details regarding
the Dante firmware can be found in the
Technical Notes section of this guide.
Reboot
This menu choice allows the Model 48D’s
microcontroller and Dante network inter-
faces to be rebooted (restarted). This is
essentially the same as if the unit had
its power temporarily removed and then
re-applied. This capability was provided
primarily to support troubleshooting activi-
ties. Performing a reboot will not typically
create any issues but will interrupt normal
Model 48D operation for approximately
one minute.