Manual

Model 374A User Guide Issue 3, August 2019
Studio Technologies, Inc. Page 22
MODEL 374A
INTERCOM BELTPACK
• The Model 374A offers a second meth-
od of activating the mic kill function.
This allows a data signal, in additional
to the Device ID command, to activate
mic kill.
• The STcontroller software application
now offers the ability to configure the
mic kill function, including allowing it
to be disabled.
• The Model 374A allows button 4 to be
used as a call button function.
Belt Clip
The belt clip is attached to the back of the
Model 374A’s enclosure by way of two
6-32 thread, Philips-head machine screws.
Unlike other the original Model 374 Inter-
com Beltpack units, the belt clip on the
Model 374A will never have to be rotated
as part of the configuration process.
(There are no configuration DIP switches
or a pushbutton switch under the belt
clip.) But if the belt clip does need to be
replaced a #1 Philips-head screw driver
would be the correct tool to remove the
machine screws.
Restoring Factory Defaults
A command in the STcontroller software
application allows the Model 374A’s con-
figuration to be reset to the factory default
values. From STcontroller select the Model
374A for which you want to restore its
defaults. Select the Device tab and then
select the Factory Defaults feature. Then
click on the OK box. Refer to Appendix A
for a list of the Model 374A’s factory de-
fault values.