Manual

Model 362 User Guide Issue 1, September 2016
Studio Technologies, Inc. Page 15
Ultimo Firmware Update
As previously discussed in this guide,
the Model 362 implements Dante connec-
tivity using the 2-channel Ultimo integrated
circuit from Audinate. The Dante Controller
software application can be used to
determine the version of the firmware
(embedded software) residing in the Ul-
timo “chip.” This firmware can be updated
by way of the Model 362’s Ethernet con-
nection. The latest Dante firmware file will
be available on the Studio Technologies
website. The Dante Firmware Update
Manager (FUM) application is used to
install the firmware. This program is also
available for download on the Studio
Technologies website.
Specifications
Power Source:
Power-over-Ethernet (PoE): class 1 (very low
power, ≤3.84 watts)
Network Audio Technology:
Type: Dante audio-over-Ethernet
Bit Depth: up to 24
Sample Rate: 44.1, 48, 88.2 and 96 kHz
Number of Receiver (Input) Channels: 2
Dante Audio Flows: 2 receiver
Network Interface:
Type: twisted-pair Ethernet, Power-over-Ethernet
(PoE) supported
Data Rate: 100 Mb/s (10 Mb/s and 1000 Mb/s
“GigE” Ethernet not supported)
Headphone Output:
Type: Dual-channel
Compatibility: intended for connection to mono
or stereo headsets or earpieces with nominal
impedance of 50 ohms or greater
Maximum Output Voltage: 3.8 Vrms, 1 kHz,
150 ohm load
Frequency Response: 20 Hz to 20 kHz, –2 dB
Distortion (THD+N): <0.002%
Dynamic Range: >100 dB
Connectors:
Headphone Output: ¼-inch and 3.5 mm
3-conductor jacks
Ethernet: Neutrik etherCON RJ45
Dimensions (Overall):
3.1 inches wide (7.9 cm)
1.6 inches high (4.0 cm)
4.0 inches deep (10.2 cm)
Mounting: intended for portable applications;
contains integral belt clip
Weight: 0.5 pounds (0.2 kg)
Specifications and information contained in this
User Guide subject to change without notice.