Manual

Issue 1, September 2016 Model 362 User Guide
Page 12 Studio Technologies, Inc.
Ethernet and Dante Status
LEDs
Three status LEDs are located below the
etherCON RJ45 connector on the Model
362’s bottom panel. The LINK ACT LED
will light green whenever an active connec-
tion to a 100 Mb/s Ethernet network has
been established. It will flash in response
to Ethernet data packet activity. The SYS
and SYNC LEDs display the operating sta-
tus of the Dante interface and associated
network. The SYS LED will light red upon
Model 362 power up to indicate that the
Dante interface is not ready. After a short
interval it will light green to indicate that it
is ready to pass data with another Dante
device. The SYNC LED will light red when
the Model 362 is not synchronized with
a Dante network. It will light solid green
when the Model 362 is synchronized with
a Dante network and an external clock
source (timing reference) is being received.
It will slowly flash green when the Model
362 is serving as the clock master as part
of the Dante network. It’s possible that
up to 30 seconds may be required for the
SYNC LED to reach its final state.
How to Identify a Specific
Model 362
The Dante Controller software application
offers an identify command that can be
used to help locate a specific Model 362.
When identify is selected it will send a com-
mand to a single Model 362 unit. On that
specific unit the green power LED, located
on the unit’s top panel, will flash on and off
approximately eight times. In addition, the
SYS and SYNC status LEDs, located direct-
ly below the etherCON RJ45 connector on
the bottom panel, will slowly flash green.
After a few seconds the LED identification
patterns will cease and normal Model 362
power LED and Dante status LED opera-
tion will resume.
Headphone Listen Level
Two rotary potentiometers (“pots”), locat-
ed on the Model 362’s top panel, allow ad-
justment of the level of the two audio input
signals as they are sent to the 2-channel
headphone output. How the pots function
will depend on how the headphone output
has been configured. Four modes
are available and allow unique output
performance. In the level/level mode the
pot labeled Ch 1 will control the level of
Dante input 1 as it is being sent to the
left channel of the headphone output.
The pot labeled Ch 2 will control the level
of Dante input 2 as it is sent to the right
output. In the level/balance mode poten-
tiometer Ch 1 will adjust the level of both
the left and right headphone outputs. Po-
tentiometer Ch 2 will control the left/right
level balance of the headphone output.
When dual-channel monaural mode has
been selected potentiometer Ch 1 will
adjust the level of Dante input 1 as it is
routed to both the left and right head-
phone output channels. Potentiometer
Ch 2 will adjust the level of Dante input 2
as it is sent to both the left and right head-
phone outputs. When the Model 362 has
been configured for the single-channel
monaural mode potentiometer Ch 1
adjusts the level of Dante input 1 as it is
routed to the left channel of the head-
phone output. Potentiometer Ch 2 will
adjust the level of Dante input 2 as it is
also routed only to the left headphone
output channel. In this mode no signal
will be present on the right channel of the
headphone output.