Datasheet

Studio Technologies, Inc. Model 362 Listen-Only Beltpack, Issue 1, Page 3
Model 362 Specifications
Power Source:
Power-over-Ethernet (PoE): class 1 (very low power,
≤3.84 watts)
Network Audio Technology:
Type: Dante audio-over-Ethernet
Bit Depth: up to 24
Sample Rate: 44.1, 48, 88.2 and 96 kHz
Number of Receiver (Input) Channels: 2
Dante Audio Flows: 2 receiver
Network Interface:
Type: twisted-pair Ethernet, Power-over-Ethernet (PoE)
supported
Data Rate: 100 Mb/s (10 Mb/s and 1000 Mb/s “GigE”
Ethernet not supported)
Headphone Output:
Type: Dual-channel
Compatibility: intended for connection to mono or
stereo headsets or earpieces with nominal impedance
of 50 ohms or greater
Maximum Output Voltage: 3.8 Vrms, 1 kHz, 150 ohm load
Frequency Response: 20 Hz to 20 kHz, –2 dB
Distortion (THD+N): <0.002%
Dynamic Range: >100 dB
Connectors:
Headphone Output: ¼-inch and 3.5 mm 3-conductor jacks
Ethernet: Neutrik etherCON RJ45
Dimensions (Overall):
3.1 inches wide (7.9 cm)
1.6 inches high (4.0 cm)
4.0 inches deep (10.2 cm)
Mounting: intended for portable applications; contains
integral belt clip
Weight:
0.5 pounds (0.2 kg)
Specifications subject to change without notice.
Studio Technologies, Inc.
Skokie, Illinois USA
© by Studio Technolog
ies, Inc., September 2016
studio-tech.com
sent to both the left and right headphone output chan-
nels. And lastly, a unique single-channel monaural mode
is provided for on-air talent cue applications where a
single-channel earpiece or earbud is being used. The two
Dante audio input channels are mixed and sent only to
the left channel of the headphone output. No audio signal
is present on the headphone output’s right channel.
Ethernet Data and PoE
The Model 362 connects to an Ethernet data network
using a standard 100 Mb/s twisted-pair Ethernet inter
-
face. The physical interconnection is made by way of
a Neutrik® etherCON RJ45 connector. While compat
-
ible with standard RJ45 plugs, etherCON allows a rug
-
gedized and locking interconnection for harsh or high-
reliability environments. An LED displays the status of
the network connection.
The Model 362’s operating power is provided by way
of the Ethernet interface using the 802.3af Power-over-
Ethernet (PoE) standard. This allows fast and efficient
interconnection with the associated data network. To
support PoE power management, the Model 362’s PoE
interface reports to the power sourcing equipment (PSE)
that it’s a class 1 (very low power) device. If a PoE-
enabled Ethernet port can’t be provided by the associ
-
ated Ethernet switch a low-cost PoE midspan power
injector can be utilized.
Future Capabilities and Firmware
Updating
The Model 362 uses Audinate’s Ultimo™ integrated
circuit to implement the Dante interface. The firmware
in this integrated circuit can be updated via the Ethernet
connection, helping to ensure that its capabilities remain
up to date.