Manual

Issue 1, January 2020 Model 348 User Guide
Page 32 Studio Technologies, Inc.
MODEL 348
INTERCOM STATION
the correct file(s) in its root folder no harm will
occur. Upon power up the green LED, located
below the USB connector, will flash on and
off rapidly for a few seconds to indicate that a
valid file has not been found and then normal
operation using the unit’s existing application
firmware will begin.
Broadway Firmware Update
As previously discussed in this guide, the
Model 348 implements Dante connectivity
using the Broadway integrated circuit from
Audinate. The Dante Controller software ap-
plication can be used to determine the version
of the firmware (embedded software) that
resides in Broadway. The STcontroller soft-
ware application can also be used to iden-
tify the firmware version. (Use the Version
selection under the Device tab.) The Dante
Firmware Update Manager (FUM) applica-
tion program has traditionally been used to
update the Broadway firmware. The Dante
Controller software application also includes
an automated method of updating Broadway
firmware. Both applications are available, free
of charge, on the Audinate website (www.
audinate.com).
Restoring Factory Defaults
A command in the STcontroller software ap-
plication allows the Model 348’s default con-
figuration selections to be reset to the factory
values. From STcontroller select the Model
348 for which you want to restore its defaults.
Select the Device tab and then select the
Factory Defaults feature. Then click on the
OK box. Refer to Appendix A for a list of the
Model 348’s factory default values.