Live Link Range Summary

Studio Technologies, Inc. Live-Link Full-Line Summary Issue 9, May 2019 • 2
Live-Link Jr. Series
Supports Two Paths of 3G Digital Video, Two Mic/Line Inputs, Line/IFB Outputs,
Party-Line and 4-Wire Intercom, Data and GPI/GPO
These versions interconnect using two strands of single-mode fiber-optic cable (not included) and provide support for the
following:
• Digital Video: one 3G/HD/SD-SDI send (camera to truck) and one 3G/HD/SD-SDI return (truck to camera)
• Mic/Line Audio: two analog mic/line sends (camera to truck) with selectable gain and 48 V phantom power
• Line/IFB: two analog line-level audio returns (truck to camera) and one 2-channel IFB output (camera) with 28 V beltpack
power
• Intercom: integrated 2-channel system; party-line (PL) with 28 V beltpack power and auto nulling on Camera End and Truck
End, single-channel 4-wire interface on Truck End
• Data/Remote Control: one RS-422 and one GPI/GPO
• Powering: Camera End powered by 12 Vdc, battery or 10-50 Vdc via a hybrid fiber/copper connector; Truck End powered by
100-240 V, 50/60 Hz or 12 Vdc
The Camera End units are portable and include an enclosure with Anton/Bauer battery mount system (contact factory for
“V-Mount” availability), handle, and rubber feet. Also included is a universal input (100-240 V, 50/60 Hz)/12 Vdc output power
supply. Available with opticalCON DUO or ST fiber-optic connectors. Truck End units mount in one space (1U) of a standard
19-inch equipment rack. Includes ST fiber-optic connectors.
Camera End with opticalCON® DUO Optical Connector
Camera End Unit: opticalCON DUO (Order Code: LLJR-CA-101)
Camera End with ST Optical Connectors
Camera End Unit: two ST Connectors (Order Code: LLJR-CA-105)
Truck End with ST Optical Connectors
Truck End Unit: two ST Connectors (Order Code: LLJR-TE-101)
Typical Configurations
LLJR-CA-101 with LLJR-TE-101
LLJR-CA-105 with LLJR-TE-101
Live-Link Jr. Accessories
Live-Link Jr. Hybrid Fiber/Copper Power Supply Installation Kit (Order Code: HFCPSK-01)
For use with Live-Link Jr. applications where camera end powering using hybrid fiber/copper cable
assemblies is desired. Includes pre-wired opticalCON DUO bulkhead connector, LC-ST fiber-optic jump-
ers, power interface board, and 48 V, 2.5 A output/universal input (100-240 V, 50/60 Hz) power supply.
Replacement 12 Vdc, 5 A Power Supply (Order Code: PS-DC-01)
Universal input, 100-240 V, 50/60 Hz; 12 Vdc, 5 amps (60 watts) output power supply. IEC C14 mains
inlet; 4-pin female XLR DC output. One included with each Live-Link Jr. Camera End unit. This power
supply is for spare or replacement only!