User manual

SE88 Filter Module - 3
LP/BP –!Mode 2 Low-Pass/Band-Pass switch.
OUTPUT – Mode 1 audio attenuator.
M2 FM –!Mode 2 frequency modulation attenuverter.
OUTPUT – Mode 2 audio attenuator.
1 V/O – One volt per octave control voltage input.
FM IN – Frequency modulation control voltage input.
M1 FM – Mode 1 frequency modulation input.
M2 FM – Mode 2 frequency modulation input.
M1 RES CV –!Mode 1 resonance control voltage input.
M2 RES CV –!Mode 2 resonance control voltage input.
M1 IN –!Mode 1 audio input.
LEVEL –!Mode 1 audio input attenuator.
M1 OUT – Mode 1 audio output.
M2 IN –!Mode 2 audio input.
LEVEL – Mode 2 audio input attenuator.
M2 OUT – Mode 2 audio output.
!
*
From 7:00 (0) to 9:00 our “Negative Resonance Saturation” adds beefiness, boosting the waveform
amplitude and taming waveform transients (most pronounced in the 3003 filter): set to 9:00 to achieve
the cleanest tone possible.!
28