User manual

5089 Filter Module - 2
All Controls and Patch Points (arranged in order of visual flow)
FREQUENCY –!Adjusts the frequency, or cut-off of the filter.
RESONANCE –!Adjusts the resonance, or “Q” of the filter. *
FULL HALF TRACK –!Switch between full and half keyboard/voltage tracking.
FREQ CV 1 –!Frequency control voltage 1 input attenuverter.
RESO CV – Resonance control voltage input attenuverter.
FREQ CV 2 – Frequency control voltage 2 input attenuverter.
INPUT – Adjusts the audio input.
OUTPUT – Adjusts the audio output.
1 V/O – One volt per octave control voltage input.
FREQ CV 1 – Frequency control voltage 1 input.
FREQ CV 2 – Frequency control voltage 2 input—get tricky with the second attempt.
RESO CV – Resonance control voltage input—use for shimmers or howling wolf tones.
INPUT – Audio input.
2x OUTPUT – Audio outputs.
!
* From 7:00 (0) to 9:00 our “Negative Resonance Saturation” adds beefiness, boosting the waveform amplitude and taming
waveform transients (most pronounced in the 3003 filter): set to 9:00 to achieve the cleanest tone possible.!
13