Manualshelf

Installation & Assembly

ManualsBrandsStudio A Home ManualsLighting2 - Light Unique / Statement Jar Pendant
12
Page 1 of 2
WARNING : Make sure that all electricity is turned off at the "J" Box before installing this fixture !!!
It is recommended that this fixture is installed by a licensed electrician !!!. Need 2 persons
BEFORE INSTALLING THIS FIXTURE :
NOTE THAT THIS FIXTURE MUST BE PROPERLY GROUNDED.
THIS FIXTURE HOLDS TWO CANDELABRA TYPE B BULBS 60 WATTS
MAXIMUM
.
REVIEW THE LIST OF PARTS
A MOUNTING STRAP
B THREADED PIPE
CCANOPY
C1 CANOPY LOOP
D DECORATIVE CHAIN
E CRIMP BAR PENDANT
E1 PENDANT LOOP
F QUICK LINK - 1PC.
F1 QUICK LINK - 1PC.
ASSEMBLY INSTRUCTIONS:
STEP ONE : Unpacking fixture:
- Unpacked all the items of Crimp Bar Pendant on a soft surface.
- Do not discard anything until assembly is complete.
STEP TWO: Adjusting the length of Decorative Chain:
- Adjust the Decorative Chain (D) to your desired length by removing the links with Pliers/Hacksaw, if needed.
- Use Quick Link (F) or Quick Link (F1) to re-attach chain to the Canopy Loop (C1) or Pendant Loop (E1).
STEP THREE: Attaching the fixture:
- Release the canopy ( C ) over the chain to access the threaded pipe (B) and
- Secure the "J" Box Mounting Strap (A) with the attachment screws to the ceiling "J" box.
- Screw threaded pipe ( B) into "J" Box Mounting Strap (A).
- Snake electrical cord through threaded pipe (B).
- Attach fixture to Threaded pipe (B) by screwing end of chain to threaded pipe.
STEP FOUR: Wiring the fixture:
- Attach the grounding conductor wire to your J box.
- Connect the live and neutral wires to the appropriate wires in the "J" box .
STEP FIVE: Assembling the fixture:
- Once the mounting strap (A) is attached to the "J" box and all the electrical wires are securely connected,
cover the mounting Strap (A) with the Canopy (C) Tighten the screw on the side of the canopy
to hold it in place.
- Install Two Candelabra Type B bulb 60W maximum (not included).
Minimum and Maximum size of the pendant with other sizes
Canopy -Diameter 5 x Ht 8" with Pipe
Pendant - Diameter 9 x Ht 23.5"
Maximum length on installation - 96" from Ceiling to bottom of pendant.
Minimum length on installation - 32" from Ceiling to bottom of pendant (by removing/cutting hanging chain)
Total wei
g
ht of pendant - 15.4 LBS.
7.90359 - Crimp Bar Pendant - Bronze
7.90364 - Crimp Bar Pendant- Antique Nickel
Assembly and Installation instructions

Summary of content (2 pages)